Mini CCD Camera

Send Inquiry
Mini CCD Camera
Details
Model No. DV-325NHP  |  1/3″ CCD, 976 × 582, 3.7 mm pinhole, 3 m BNC
1/3″ CCD at 976 × 582 — a true 960H PAL
700 TVL horizontal resolution
3.7 mm pinhole lens, 66° × 52° field of view;
1 W at 12 V DC, 83 mA — runs from the same supply as the DVR
25 × 25 mm face, 17.2 mm deep, Ø5 bracket hole
Digital wide dynamic range, 2D noise reduction and an OSD menu available as build options
−20 °C to +60 °C operating
Category
Analog Camera
Share to
Description

Product Description

The DV-325NHP is a 23 × 23 mm board camera in a 25 × 25 mm housing, built around a 1/3″ CCD at 976 × 582 behind a 3.7 mm pinhole lens. It delivers 700 TVL of PAL composite on a 3 m BNC tail and draws 1 W from 12 V DC. Digital WDR, 2D noise reduction and an on-screen menu are build options; the base build is fixed. Minimum illumination is 0.001 lux at F1.2 with frame integration - at 25 fps the usable figure is 0.65 lux. The 26 mm face and 17.2 mm depth suit fascias, door frames and lift cars where a dome will not fit.

1

 

Product specification

 

2.1 Model numbering

Field

Value

Note

Model

DV-325NHP

Appears on the current page only as a caption under the drawing, never in the heading or the table.

HP

High-resolution build

700 TVL, 960H raster.

 

2.2 Sensor and video

Parameter

Value

Image sensor

1/3″ Sony CCD, 976 × 582 effective

Sensor status

Discontinued

Pixel pitch implied

4.9 µm horizontal, 6.2 µm vertical

Scanning

2:1 interlaced, 625 lines, 50 fields/s

Horizontal resolution

700 TVL

Video output

1.0 V p-p composite into 75 Ω, sync negative

Sync

Internal

S/N ratio

≥ 50 dB

Gamma

0.45

White balance

Auto, 2500–10000 K

Minimum illumination

0.001 lux at F1.2

 

2.3 Lens

Parameter

Value

Focal length

3.7 mm

F-number

Not stated

Field of view at 3.7 mm

66° H × 52° V (78° diagonal)

Lens seat

Not stated

IR-cut filter

Not stated

 

2.3 Image processing and menu

Feature

Status

What it actually does

Digital wide dynamic range

On

A DSP tone curve, roughly two stops of highlight compression. The source table calls it "electronic wide dynamic (AGC OFF, optional)" and gives no dB figure, which conflicts with "automatic gain: auto".

2D digital noise reduction

Optional

Frame-domain averaging. Helps a still scene, smears a moving subject.

OSD menu

Optional

The table says "Menu: support", the bullets say "optional". Both cannot be true of the same build.

Backlight compensation

On / off

Centre-weighted; no zone selection is described.

Day / night

Software switch

Colour to black-and-white matrix only.

Auto gain

Auto

Gain range in dB is not stated.

 

2.5 Electrical

Parameter

Value

Supply

12 V DC

Consumption

1 W max

 

2.6 Mechanical

Parameter

Value

Housing

25 × 25 × 14 mm

Bracket hole

Ø5 mm

Board

23 × 23 mm PCBA

Weight

TBD

 

2.7 Environment and compliance

Parameter

Value

Note

Operating temperature

−20 °C to +60 °C

Narrower than the −30 to +70 quoted on the other analogue page in this category.

Humidity

Below 90 % RH, storage only

No operating humidity figure; relevant if the camera sits behind a shop window.

Ingress protection

Not specified

Indoor use only. Four screws and an unsealed face.

Certification

Not listed

CE, FCC and RoHS appear elsewhere on the site but not here.

 

Interface & pin definition

 

4.1 Video output

Item

Specification

Note

Connector

BNC female, 75 Ω

The source page calls it a "BNC mother head".

Cable length

3000 mm

Fixed tail, not a connector on the housing.

Signal

1.0 V p-p composite, sync negative

PAL, 625/50.

Shield

Connected at the camera end

Not stated; matters for ground loops on long runs.

 

4.2 Power entry is missing

The camera draws 1 W from 12 V DC - 83 mA - but the only conductor on the page is a 3 m BNC. A BNC carries a single coaxial signal, and no DVR in this class supplies 12 V on its video input. As written, the product cannot be powered.

Conductor needed

Stated on the page

Required

Video

3 m BNC female

Yes

Power

-

Two conductors, 12 V DC, 83 mA. Either a flying 2-pin lead or a DC jack on the tail, with the polarity marked.

Menu / OSD

-

Only if the optional menu build is ordered - normally UTC over the coax.

 

Dimensions

product-472-259

Typical applications

 

Application

Why this camera fits

Confirm before quoting

ATM and kiosk fascia

25 × 25 mm face and 17.2 mm depth mount behind a 26 mm cut-out; the 3 m tail reaches the cabinet interior.

66° × 52° at 3.7 mm - check it covers the user's shoulders, not just the keypad.

Lift car ceiling and door frames

No dome, no visible lens ring, four-screw flush plate.

Lift cars run at 200–800 lux; 0.65 lux is ample, but the 12 V supply is usually in the shaft, not the car.

Retail loss prevention behind a perforated panel

Small enough to sit behind a 5 mm perforation; no IR LEDs to give the position away.

No IR-cut removal and no IR illumination - the scene needs ambient light above 1 lux.

Replacing a dead 960H pinhole camera in an existing DVR estate

Same BNC, same PAL timing, same 12 V.

No line-lock: expect vertical roll when the DVR switches between AC-powered channels.

 

Not the right fit for outdoor use, for anything below about 1 lux, for a site being cabled for IP, or for machine vision - an interlaced 50-field signal is the wrong starting point for measurement. The category also lists a Miniature AHD camera; that is the part to quote where the recorder is newer and the customer wants more than 0.57 MP.

 

Customization & ordering

 

Option

Available

Effect on the order

Focal length

2.8 mm (90° H) / 3.7 mm (66° H) / 6 mm (44° H)

Changes the part number and the coverage. 2.8 mm is the lens that makes the 90° in the current copy true.

Video standard

PAL 976 × 582 as built

An NTSC build at 976 × 494 is not listed; if the N in the model number is meant to signal it, that variant has to exist.

OSD menu

With / without

State the entry method (UTC or button pad) and whether the menu build changes the price.

Noise reduction

2D DNR on / off

DSP build option; no change to the lens or the housing.

Cable

3 m standard; 1 m and 5 m on request

Longer tails are the only way to reach a supply that is not in the same cabinet.

Bracket

With / without

The 17.2 mm depth is measured with the bracket fitted; without it the body is 14 mm.

Hot Tags: mini ccd camera, China mini ccd camera manufacturers, suppliers, factory, ccd compact digicams, ccd hd camera, ccd camera digital, c mount ccd camera, ccd and cid camera, three ccd camera

Send Inquiry