Product Description
The AL-IPC2 is a 2 MP network camera built to sit inside equipment rather than on a wall bracket: a 46 × 46 × 48.2 mm finned aluminum cube, 2 W over PoE, 1920 × 1080 at 30 fps through ONVIF 16.12. A 2.95 mm M12 barrel covers 85° × 55° - 7.33 m wide at 4 m. Motion detection with 396 zones and four privacy masks run inside the camera; object classification runs on the recorder or VMS, which is what keeps the budget at 2 W. H.265 holds 1080p at 4 Mbps, 42 GB a day. There is no mounting insert and the cable leaves the top face.
AL-IPC2

Product specification
2.1 Model and build
|
Field |
Value |
|
Model |
AL-IPC2 |
|
Function |
2 MP network camera with on-board motion detection and privacy masking |
2.2 Sensor and pixel
|
Field |
Value |
|
Sensor |
1/2.8″ CMOS, 1920 × 1080, 2.07 MP. Part number not stated. |
|
Pixel pitch |
2.81 µm - derived: 2.95 mm at 85° needs a 5.41 mm wide array. A 2.9 µm pixel would give 86.7°. |
|
Active area |
5.40 × 3.04 mm, 6.20 mm diagonal. That is 1/2.9″ by the strict definition and is sold as 1/2.8″. |
|
Shutter |
Electronic rolling, 1/5 s to 1/20,000 s |
|
Minimum illumination |
0.001 lux at F1.2 - a long-exposure figure, see table 5 |
|
Usable at 30 fps |
1.5 lux in colour, 1.26 lux at 25 fps (derived) |
|
Day / night |
Colour and monochrome modes. IR-cut type and switching method not stated; no IR illuminator is fitted. |
|
Signal to noise |
30 dB quoted - see table 6 |
|
Dynamic range |
100 dB quoted - see table 6 |
2.3 Lens, field of view, and what an object is worth
|
Field |
Value |
|
Focal length |
2.95 mm |
2.4 Encoding and streams
|
Field |
Value |
|
Compression |
H.265, H.264, MJPEG |
|
Main stream |
1920 × 1080, 1280 × 960, 1280 × 720, 960 × 576, 960 × 540, 800 × 600, 960 × 480, 720 × 576, 704 × 576, 720 × 480, 640 × 480, 640 × 360 |
|
Sub stream |
640 × 480, 640 × 360 |
|
Third stream |
640 × 480, 640 × 360 - but the page also says "dual streams can be configured" |
|
Frame rate |
1 to 25 fps at 50 Hz, 1 to 30 fps at 60 Hz. An IP camera has no PAL or NTSC; it has an anti-flicker frequency. |
|
Bit rate |
64 kbps to 16 Mbps, CBR or VBR |
|
Default bit rate |
Not stated - without it, storage cannot be sized |
|
GOP / I-frame interval |
Not stated |
|
OSD |
Not stated. Channel name and timestamp are normally required. |
|
ROI / SVC |
Not stated |
2.7 Network, protocols and power
|
Field |
Value |
|
Ethernet |
One RJ45, 10/100 Mbps adaptive |
|
ONVIF |
16.12 is the release date, not a profile level. Profile S / T / G to be stated. |
|
RTSP |
Supported; the URL is not published. Without it the NVR step is guesswork. |
|
Other protocols |
TCP/IP, UDP, SMTP, HTTP, FTP, DHCP, UPnP, RTP, RTSP, PPPoE, NTP, DDNS, 802.1x, SNMP, RTMP |
|
Not implemented |
HTTPS, GB/T 28181, SFTP. GB/T 28181 is the first gate on Chinese public-sector projects. |
|
Web client |
"Internet Explorer 8.0 or later" and "Google Chrome" in the same row. Chrome removed NPAPI in 2015; IE retired in June 2022. |
|
Simultaneous clients |
Not stated |
|
Power |
Value |
|
Inputs |
802.3af PoE on the RJ45, or 12 V DC. The DC connector is not described anywhere. |
|
Consumption |
2 W ±20 %, so 1.6 to 2.4 W |
|
Current at 48 V |
≈ 42 mA |
|
Current at 12 V |
≈ 167 mA |
|
As printed: "POE 1A" |
1 A at 48 V is 48 W, twenty-four times the load; at 12 V it is 12 W. Neither is a power requirement - it is an adapter rating. |
|
PoE class |
2 W falls in Class 1 (3.84 W at the PD), margin 1.9×. Class 2 gives 3.2×. |
|
Cable loss |
100 m of Cat5e, 18.76 Ω loop, drops 0.78 V at 2 W - 1.6 %. PoE is not the constraint here. |
2.8 Mechanical and environment
|
Field |
Value |
|
Front face |
46 × 46 mm, ±0.15 |
Interface & pin definition
RJ45 and PoE pinout
|
Pin |
10/100 data |
802.3af Mode A |
802.3af Mode B |
|
1 |
TX+ |
+48 V |
- |
|
2 |
TX− |
−48 V return |
- |
|
3 |
RX+ |
+48 V |
- |
|
4 |
Spare |
- |
+48 V |
|
5 |
Spare |
- |
+48 V |
|
6 |
RX− |
−48 V return |
- |
|
7 |
Spare |
- |
−48 V return |
|
8 |
Spare |
- |
−48 V return |
Because only pins 1, 2, 3 and 6 carry data at 10/100, both Mode A and Mode B are electrically available. State which one the camera accepts, and whether a PoE splitter or injector is supplied - a customer holding a Mode B injector will otherwise buy a camera that never powers up.
Dimensions

Typical applications
|
Application |
Why this camera |
Confirm first |
|
Self-service terminal, ATM fascia |
46 mm cube, 2 W, 0.92 × 0.52 m at 0.5 m |
Near focus limit is 0.65 m - a 0.3 m reading distance will be soft |
|
Kiosk and vending enclosure |
No fan, 1.6 to 2.4 W, PoE from the same run |
How the cube is fixed: there is no insert or bracket hole |
|
Queue counting and people detection |
85° wide view; detection runs on the recorder |
ONVIF profile; the page gives a release date, not a profile |
|
Face capture at a door |
79 px across the face at 2 m |
Beyond 2 m the face drops under 80 px - this is not an identification camera at 4 m |
|
Privacy-sensitive rooms |
Four mask zones set in the camera |
Mask count and whether masks follow the crop on sub streams |
|
Equipment integration, OEM |
Finned aluminum body, 12 V or PoE, ONVIF out |
Board dimensions and mounting bosses are not published |
|
Vehicle and plate at a gate |
230 px on a 0.44 m plate at 2 m |
Rolling shutter at 30 fps; a plate at 30 km/h moves 0.28 m per frame |
Customization & ordering
|
Field |
Value |
|
Base model |
AL-IPC2 |
|
Power option |
PoE |
|
Lens option |
2.95 mm as standard. Other focal lengths would change the field of view and are not offered on the page. |
Hot Tags: 2MP Object Recognition IP Camera, China 2MP Object Recognition IP Camera manufacturers, suppliers, factory, ip camera v380 pro, lemnoi camera, best night vision security camera, ip 4k security camera, p2p ip camera, 2 way audio security camera
